Home > Blog > Content

What happens when a universal joint goes bad?

Dec 15, 2025

When a universal joint malfunctions, it directly impairs the power transmission efficiency of a vehicle's powertrain and can also trigger a range of issues-including abnormal driving noises, handling irregularities, and even serious safety risks. The specific fault symptoms vary based on the universal joint type (e.g., cross-shaft universal joint or ball-cage constant-velocity (CV) joint) and the extent of damage, with key manifestations as follows:

Obvious Abnormal Noises

Cross-shaft universal jointIn the early stages of failure, a metallic "clunking" or "clicking" impact noise emanates from the propeller shaft when the vehicle starts, shifts gears, or turns. This occurs due to wear-induced clearances between the cross shaft and needle roller bearings, or loose bearings. If wear becomes severe, a dull, persistent noise will occur while driving, with the noise frequency increasing as vehicle speed rises.

Ball-cage constant-velocity (CV) jointThe most characteristic symptom is steering-related noise. When the vehicle turns (especially at low speeds and large steering angles), a "clicking" or "squeaking" sound originates from the inner side of the wheel. This is caused by worn steel balls and raceways inside the CV joint, or by mud and sand infiltrating through a cracked dust boot. If a damaged dust boot is not repaired promptly, lubricant leakage will occur, and the abnormal noise will gradually intensify.

Interrupted or Jerky Power Transmission

Severe wear, seizing, or fracture of internal universal joint components will disrupt smooth power delivery. For example, the vehicle may shake during startup and exhibit noticeable jerking during acceleration. In extreme cases, complete universal joint failure will cut off power transmission entirely, rendering the vehicle inoperable. In the worst scenarios, the propeller shaft may detach, leading to a catastrophic traffic accident.

Abnormal Driving Attitude and Handling

In front-wheel-drive vehicles with faulty ball-cage CV joints, steering will feel heavy, steering precision will decline, and the vehicle may even pull slightly to one side.

Loose cross-shaft universal joints can cause propeller shaft imbalance, resulting in vehicle body or steering wheel vibration at high speeds and compromising driving stability.

Spread of Component Damage

A cracked universal joint dust boot, if left unrepaired, will allow continuous intrusion of sand and rainwater. This not only accelerates wear of the universal joint itself but also can cause rust and damage to adjacent transmission components (e.g., half-shafts and bearings), leading to a substantial increase in repair costs.

Send Inquiry